Microsoft G7VP2 Bedienungsanleitung PDF herunterladen (Seite 31)

Hardware Installation

2.9.11 J13 (LEDs and Switches)

SP-LED - ATX 5VSB Standby LED

This LED will light when the 5VSB power is active.

ATX -SW - AT X P owe r S wi t c h

Depending on the setting in the BIOS setup, this switch is a dual

function power button that will allow your system to enter the Soft-

Off or Suspend mode. Refer to Soft-Off By PWRBTN in the Power

Management Setup (Chapter 3) of the Award BIOS.

HD-LED - Primary/Secondary IDE LED

This LED will light when the hard drive is being accessed.

G-LED - Green LED

This LED will light when the system is in the Suspend mode.

G-SW - Green Switch

This switch will allow your system to enter the Suspend mode. To

wake up the system, PM Events in the Power Management Setup

(Chapter 3) must be enabled so that access to the specified IRQ

will allow the system to wake up completely from the Suspend

mode.

H-RST - Reset Switch

This switch allows you to reboot without having to power off the

system thus prolonging the life of the power supply or system.

SPEAKER - Speaker Connector

This connects to the speaker installed in the system chassis.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 69 70

Keine Kommentare

Microsoft G7VP2 Bedienungsanleitung Seite 31