Microsoft Windows NT 4.0 Guide Bedienungsanleitung PDF herunterladen (Seite 9)

Applications Compatibility Scripts for Windows NT Server, Terminal

Server Edition

Resolution:

Terminal Server handles this situation by providing an install mode. You enter

install mode by issuing the command “change user /install” at a cmd prompt or by

selecting “All users begin with common application settings” from the Add/Remove

Programs wizard. Once you have entered install mode, you can install the

application. Each registry setting that is written to HKEY_CURRENT_USER will be

mirrored into a special location within HKEY_LOCAL_MACHINE. When your

installation is complete, the “change user /execute” command takes you out of

install mode. If you’re using the Add/Remove Programs wizard, you are

automatically taken out of install mode after you click the finish button. Terminal

Server propagates the mirrored information in HKEY_LOCAL_MACHINE to each

user’s HKEY_CURRENT_USER when the information is needed. The location of

the mirrored registry entries are:

HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\WindowsNT\CurrentVersion\Ter

minalServer\Install.

Application fails to create HKEY_CURRENT_USER settings on install:

An application may not create HKEY_CURRENT_USER registry settings during

installation. Instead, it might wait until the first time a user runs the program. If the

person who installs the application does not run it while install mode is still active,

the HKEY_CURRENT_USER settings won’t get copied to

HKEY_LOCAL_MACHINE and the automatic propagation won’t occur.

The first time each user runs the application, their HKEY_CURRENT_USER will be

loaded with the default settings. Depending on the application, this may or may not

be appropriate. If the default settings aren’t sufficient, then they would need to be

corrected for each user individually.

Resolution:

Before leaving install mode, the administrator can run the application. If the

administrator has already left install mode but hasn’t run the application, just re-

enter install mode with “change user /install” and run the application. If the

administrator has already run the application while in execute mode, create another

administrator account. Log on with this new account, change to install mode, and

run the application. In all cases, use “change user /execute” to leave install mode

after running the application.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 34 35

Keine Kommentare

Microsoft Windows NT 4.0 Guide Bedienungsanleitung Seite 9