Microsoft Windows NT 4.0 Guide Bedienungsanleitung PDF herunterladen (Seite 20)

2-8 Sun StorEdge A5000 Installation Guide for Windows NT Server 4.0 • October 1998

Verifying Configuration of the Host Bus

Adapter Driver and Physical Disks

Verify that your Windows NT host can see the Sun StorEdge A5000 disks.

1. Select Start → Settings → Control Panel → SCSI Adapters.

2. Click on the entry for the QLogic QLA2000/QLA2100 host bus adapter and then

click on the (+) to the left of the Bus number.

Note – Under certain circumstances, the SCSI Adapters utility under the Control

Panel may not report accurate information.

If the QLogic host bus adapter and disks are not displayed in the Devices tab of the

SCSI Adapters window, select the Drivers tab and verify that the QLogic

QLA2000/QLA2100 driver is started; if the driver is not started, contact your

Customer Service representative for troubleshooting assistance.

If the QLogic driver is started, run the Windows NT Disk Administrator and verify

that it correctly displays the number and sizes of all your disks.

3. As shown in

FIGURE 2-5, you should see each device that is attached to the Fibre

Channel host bus adapter. (In this case, you will see all of the devices that your

disk array contains.)

1 2 ... 15 16 17 18 19 20 21 22

Keine Kommentare

Microsoft Windows NT 4.0 Guide Bedienungsanleitung Seite 20