Microsoft Windows NT 4.0 Guide Betriebsanweisung PDF herunterladen (Seite 115)

Chapter 4 Using the Microcal Diagnostic Utility 115

To change the default communication parameters:

1. Select Configure from the Microcal Main menu.

2. Select Communication Parameters. The following menu appears:

3. Highlight the parameters you want and then press Enter.

The controller stores the changes in non-volatile memory.

Therefore, your changes remain in effect until you change them

again.

Specifying COM Port and Interrupt Settings

If you have several COM devices or a switch box that can alternate

devices, you may want to specify at startup the COM port being used

by the touchscreen. You can load Microcal to go right to the correct

COM port for the touchscreen, without the usual polling.

When you enter the Microcal command, you have several options for

specifying the COM port and the interrupt.

For a list of Microcal startup options, access the DOS command

prompt and enter the following command:

MICROCAL /?

Recommended setting

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 143 144

Keine Kommentare

Microsoft Windows NT 4.0 Guide Betriebsanweisung Seite 115